MPPT 100/50 undated firmware 4 days ago. Now will not charge. Do not know if related. System shows 65 volts in but no charging. I see current in PV input lines. Victron Connect is showing NO errors. I am stumped.
asked
Will smart MPPT 100/50 show an error if internal fuse blown?
Have you tired a power cycle?
Disconnect pv, disconnect battery.
Reconnect battery, check settings, reconnect pv.
You could also try a reset to defaults and then re program after that. If it is still not charging then there may be an issue internally.
How did you measure current in the PV? with clamp meter?
@dagheen
I'm curious about your daily logged battery V's, Do you have something else charging at the same time?
Definitely a better point there. Battery voltage is clearly going up each day, but the mppt has not provided the charge.
I have tried the reset to defaults and reprogram. I have also disconnected solar and unplugged from the battery to get a reset. I would expect some type of error if it is an internal fuse, but I see none.
@dagheen
You will need to try it with no other charge sources attached to the battery and with its voltage below the rebulk offset.
For a fuse to blow for no particular reason is unusual especially if it has been working.
Is the system networked somehow? Maybe remove it from the network. Something was upset firmware or set up wise after the firmware update.
There are further test instructions in this document.
Update. Again disconnected PV and battery leads. Wait 5 minutes. Hook up battery again. Reset defaults. Adjustment programming for my battery. Hook up PV leads again. Still no current.
Forgot to mention that I measured the Amp reading through PV lines at Victron MPPT at 7.8 amps. Max for my system is 9.38 amps. I the lines show voltage and current, but something in Victron is not releasing this current for charge.
