Hi!
I'm trying to install the EV Charger and I have some problems.
It's a single phase installation, I can see the device in VRM / Cerbo.
On the other hand, I see my plant in the display of the EVCS - so I guess everything is fine here.
But as soon as I start charging - doesn't matter if in manual or automatic mode - after some seconds, the stations stops charging with the message "charged".
The car (Tesla Model Y 2023 with original blue Type 2 Cable 3phases) shoes a message like "charger not ready, no power".
The actual power is always 0 kW in the car display, as well as in the chargers display.
Car is 70% charged, charge limit is 90%.
CP Calibration does not help.
Any ideas?
Thank you!