question

adeart avatar image
adeart asked

VeConfig and CCGX setup aettings after Firmware Update

device-list.jpgScreenshot 2023-05-01 133648.pngScreenshot 2023-05-01 133810.pngI have just updated my MultiPlus firmware from v158 to v502, after update my system have gone into permanent overload and Fault and also AC Input is still displaying disconnected after the update

VE.Bus
device-list.jpg (37.8 KiB)
screenshot-2023-05-01-133648.png (113.1 KiB)
screenshot-2023-05-01-133810.png (37.0 KiB)
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

2 Answers
nickdb avatar image
nickdb answered ·

Did you reapply the configuration after the update? The update itself will reset the configuration to default.

The GX will also need to be current.

4 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

adeart avatar image adeart commented ·
No i did not completely, I seem to have lost all previous settings


0 Likes 0 ·
Show more comments
JohnC avatar image
JohnC answered ·

@Adeart

You'll need to clear that Fault state in the Multi first. You must have done this update with VEFlash, so make sure the MK3 adaptor isn't still connected. You could try a Redetect System (In the CCGX, Multiplus > Advanced).

1 comment
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

adeart avatar image adeart commented ·

I have tried a redetect, it does not work, Tried a total shutdown of the system and the Solar charger, still the same. I am contemplating a firmware roll back What do i do next???

0 Likes 0 ·

Related Resources

What is VE.Bus?