Hello,
I am looking at the Seplos BMS 200a 16s.
Does anyone have any experience good or bad with this BMS and connecting via CAN Bus to a cerbo GX.
Many thanks,
Rich
asked
Seplos BMS
I'm using this model, but the old one (10C) and I'm fully satisfied with it.
particularly since Seplos issued a new firmware (V2.9) correcting the fuzzy CVL calculation implemented in V2.8 firmware.
With this firmware you can now define your own CVL from DVCC menu as the one from the BMS is fixed at 58,2V and you can have access to detailed values of te lowest and highest voltage from all connected racks, that's a great improvement
Many thanks Jeanmarie.
Good news.
I have 4 x Seplos DIY batteries on the way with 280aH EVE grade A batteries. These have the 10e BMS.
I currently have a 24v Multiplus with AGM batteries. I am upgrading to 48v (Mutliplus II) just due to the batteries coming to the end of their life. - System is working great and love the Victron gear.
Could you share your DVCC settings as fairly new to LI.
Also was thinking of connecting each battery to a bus bar via a battery switch rather than using the parallel throughs on the battery.
Do you have more than 1 battery.
Sorry for all the questions.
Many thanks.
Rich.
P.S. - We have just putting 900 panels on the roof of our warehouse and getting 288kw regularly :-)
Many thanks Mike,
I thought that the Multiplus II had better grid compatibility.
I am using ESS and only have 1 x AC Input.
Quite a good article below.
https://cleversolarpower.com/victron-multiplus-vs-quattro/
Good luck with your install. I will let you know how I get on.
Cheers
Rich
