question

thanar avatar image
thanar asked

Puzzled: What's the right way to setup a MultiPlus-II on ESS?

According to the ESS design and installation manual, in order to set up Multiplus-II for ESS, I have to use VEConfigure. Which I thought it has been replaced my VictronConnect. But you can't use VictronConnect to configure the grid country code. So I guess I will have to use VEConfigure then, right?

So, what are the settings that CANNOT be adjusted through VictronConnect or through a GX device or even through the VRM? Because all recent tutorials or training material focus on GX and VictronConnect and then occasionally shoot a VEConfigure screenshot, which is getting into my nerves.

Thanx for any insights.

Multiplus-IIESSVictronConnectVEConfigure 3
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
Alexandra avatar image
Alexandra answered ·

@thanar

You cannot use Victron Connect to install any assistants currently. That is why all the manuals for each supported battery show how to set it with VE Config.

It is much easier to firmware update and set up three phase and parallel and all the basics with Victron Connect. So use that for the basics.

Then use VE Config to disable virtual switch and run the ESS assistant.

4 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

thanar avatar image thanar commented ·

Thanx for the reply Alexandra,

So, if I understand correctly, VEConfigure should be used to select the country grid code, disable the virtual switch and send the ESS assistant to the MultiPlus.

However, I am puzzled as to why Victron has not yet got into the trouble of putting together a ESS-specific assistant how-to, since they have ditched the different hub assistants they used to have and now focus solely on the ESS system. I have not been able to locate a comprehensive ESS how-to, focused on the initial settings, which makes the whole ESS installation manual kind of "under contruction". Trying to locate stuff on the manual results to "page moved" and screenshots of strange assistants on how-tos.

0 Likes 0 ·
Rob Duthie avatar image Rob Duthie thanar commented ·
Correct
0 Likes 0 ·
Show more comments