Can Multiplus use temperature and voltage readings from MV-712 thru Venus Device? If so, how do you set it up?
This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Can Multiplus use temperature and voltage readings from MV-712 thru Venus Device? If so, how do you set it up?
Yes, using the Venus device menus enable DVCC, then enable SVS (shared voltage sense) & STS (shared temperature sense).
Yes, no problem.
Just go into the settings and activate DVCC, then SVS and STS.
I already did that and couldn't make it work properly, maybe my multiplus is dead. I made a separate question for my case, I would really apreciate if you could look at it.
To keep the discussion on track, I have provided you with an answer in your post - please refer to that.
MultiPlus Product page / Quattro Product page
MultiPlus 230V Manual / Quattro 230V Manual
MultiPlus 230V Datasheet / Quattro 230V Datasheet
VE.Bus Error codes / VE.Bus configuration guide
Victron BMV battery monitors product page
Additional resources still need to be added for this topic
Victron temperature sensor disambiguation table - which product supports which sensor
8 People are following this question.