This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hello,
I have a Batrium BMS That is connected to the Cerbo gx using the CANBUS. The BMS has a an issue where it freezes for an undetermined amount of time then restarts normally. When it freezes for more than one minute (not sure the exact duration), my inverters turn off. As soon as the CANBUS data is back, the inverters turn on.
Is there a way to program a delay before the inverters turn off?
Unfortunately you cant have the best of both worlds.
If the can is disconnected the system has to protect itself and batteries by stopping everything. So safety.....
Maybe use the inverter as the battery monitor until you can work out why it is disconnecting?
I totally agree with the protection mechanism. I was just checking if there was a way to increase the delay.
