I’m about to add a grid import meter to a system on a boat to show shore power consumption. the system comprises a Cerbo gx, a non Victron charger, two Victron mppt controllers and a smart shunt. To test the meter prior to install I hooked it up to my Rasberry pi setup at home. When configured as a grid meter, it actually displays to the right of the graphical Victron inverter charger as AC loads rather than the AC input to the left of it As I expected. Is this a peculiarity of doing this on a pi or is it going to be the same on the Cerbo. If so it’s not really an accurate representation. yes it will measure but the display is odd. Any ideas how to configure it differently?