question

dbasmb avatar image
dbasmb asked

Trying to believe SOC but voltage is lower than I would expect

I know you can’t check the state of charge of a battery based on voltage and therefore one should go by the SOC on the Victron, but I always have trouble believing the Victron when, for example it says SOC is 75% and voltage is 12.15 (I’m assuming 12.2 to be the 50% point). My question is: in a 12V system, what range of voltage should one not be surprised at when the SOC is 50%? In my example, should I just blow through 12.1V and only look at SOC or should I be concerned that something isn’t right? I’ve had the Victron for years and I never go by SOC because of that issue……so why have the Victron if I can’t believe it!

SOC
6 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Matthias Lange - DE avatar image Matthias Lange - DE ♦ commented ·

What is "the Victron"? I guess a BMV or SmartShunt?

What type of battery?

Settings of "the Victron"?

0 Likes 0 ·
dbasmb avatar image dbasmb Matthias Lange - DE ♦ commented ·
Sorry, I didn’t include the details of my setup thinking it was a basic question. Hope this helps:


Victron BMV - 700

3x group 27 lead acid batteries in parallel

Mounted in a boat

Settings:

Bat Cap: 327

Charge Voltage: 13.2

Tail current: 0.5

Peukert: 1.2

efficiency: 85%

No load current: 0

Let me know if you want more info.


So, the direct question is if the SOC is 50% for example, what is the voltage that would look out of line and unexpected - 12.1, 12.0, 11.5, 11.0, etc? I recognize that the voltage really is meaningless unless there has been no load for a time, but after using 12.2 volts as a lower limit for so many years, it’s tough to teach old dogs new tricks!

0 Likes 0 ·
Show more comments
1 Answer
guy-cashmore avatar image
guy-cashmore answered ·

Lots of variables!


Measuring SoC using voltage requires zero load on the batteries for a period of time before measuring, basically when you remove the load the voltage will slowly climb and you need to wait until it has stabilised.


You also need to take into account the temperature of the batteries and the chemistry type (gel, AGM, flooded etc) and even these vary a little between different brands.


So as you already know, given these issues, it's not regarded as a very accurate method of measuring SoC. My suggestion is get a SmartShunt!


Guy

3 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

kevgermany avatar image kevgermany ♦♦ commented ·
There's a BMV in already. Smart shunt is redundant.
1 Like 1 ·
seb71 avatar image seb71 kevgermany ♦♦ commented ·

He answered before the OP wrote about the BMV.

1 Like 1 ·
kevgermany avatar image kevgermany ♦♦ seb71 commented ·
You're right. Wanted to make sure OP wasn't confused.
1 Like 1 ·

Related Resources

Additional resources still need to be added for this topic