Multi with old firmware on Cerbo .
Question: Which function will work and which function will not work?
This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Multi with old firmware on Cerbo .
Question: Which function will work and which function will not work?
As @JohnC mentioned big call. What inverter what firmware?
The Cerbo GX manual is very clear on this topic. Check out the DVCC Requirements, section Firmware version.
Minimum firmware version for a Multi/Quattro is 422. Don't use DVCC if your Multi does not meet this requirement.
You might have issues with assistants but in theory the core capabilities should work, whether or not it is tested anymore, can't tell you but the cerbo docs state supported firmware:
The earliest version of the VE.Bus devices which can be connected to the Cerbo GX is 19xx111 or 20xx111, which were released in 2007. VE.Bus firmware 26xxxxx and 27xxxxx are also supported …but 18xxxxx is not.
edit: Stephanie has confirmed the DVCC requirements so no go there.
MultiPlus Product page / Quattro Product page
MultiPlus 230V Manual / Quattro 230V Manual
MultiPlus 230V Datasheet / Quattro 230V Datasheet
VE.Bus Error codes / VE.Bus configuration guide
Additional resources still need to be added for this topic
Remotely Update VE.Direct Firmware
VictronConnect manual / Firmware updates
Updating a Victron Smart Solar MPPT Charge Controller with Victron Connect
VictronConnect configuration guide for VE.Bus products - Firmware Updates
53 People are following this question.