question

d-ferdi avatar image
d-ferdi asked

night/sunrise detection problem mppt 75/50 with firmware 1.59

hello,

i have a problem with one of my mppt 75/50 and this is the only with the newest firmware 1.59 all other have version 1.17 and one 1.19.

to get date in the night, i install a little circuit to get power to the mppt und this works fine with all mppt 75/50 only this with the newest firmware makes problem to detect the new day. i reduce the supply voltage to less then 15v in my 24V system, but this don't help, next i will try to reduce it to less then 10V.

why does the mppt don't detect a new day, if the pv-voltage is over 5v under the battery-voltage over more then 12 hours ?

i don't like it, if i must insert a circuit, which set the voltage for a short time to 0 V.

goodby

MPPT Controllers
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
klim8skeptic avatar image
klim8skeptic answered ·

why does the mppt don't detect a new day, if the pv-voltage is over 5v under the battery-voltage over more then 12 hours ?

It would seem that externally powering the PV input, even with a low voltage keeps the mppt awake and unable to detect a new day.

The 75-50 mppt appears to start operating at PV voltages of about 7v, YMMV.

75-50-start-up.png


75-50-start-up.png (42.7 KiB)
5 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

d-ferdi avatar image d-ferdi commented ·
hello,

i have 7 mppt 75/50 installed and only on don't detect a new day. all other detect a new day and the pv-voltage is between 20 V and 25 V in my 24-volt-system and the mppt which doesn't detect a new day have a pv-voltage of 14V and it is the only mppt with firmware newer as 1.19 all other have 1.17 or 1.19 as firmware.

i will try to reduce the pv-input-voltage to the minimum which is needed, to get the mppt online.

i have the problem, that i lost the connection to cerbo-gx if the mppt have no power, so i install a diode and a resistor between the battery and the pv plus pole. and it works find, only the mppt with the newest firmware makes problems.

i try to sync the mppts with my software, but this mppt don't support that.

goodby

0 Likes 0 ·
JohnC avatar image JohnC ♦ d-ferdi commented ·

Hi @d_ferdi

I'm fascinated. Please tell us more about what you want to achieve here. You say "to get date in the night", but why, what do you mean?

Without going back through fw changelogs, it's also possible that the 1.59 is already 'alive', and fiddling with it's Vpv is preventing it doing what you actually want.



0 Likes 0 ·
Show more comments