question

schmit01 avatar image
schmit01 asked

12v batteries - Allowable voltage deviation prior to balancing

Hey All

Learning here so go easy.

When purchasing 2x 12v Lithium batteries for a 24v phoenix inverter, what is an allowable voltage deviation between the batteries when fully charged and settled prior to balancing them?

Both accept the full AH rating charge and a little more when charged from 100% DOD but one settles at 13.6v and the other at 13.1v. I would think this will cause issues when charging in a 24v arrangement?

Also when I put a load on the 13.1v battery it jumps up to 13.35v, then back down to 13.1v when disconnected. Making me think it is faulty and enough for me to return the battery for a replacement?

Any thoughts would be appreciated.

Lithium Battery
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

2 Answers
kevgermany avatar image
kevgermany answered ·

Could be an internal imbalance between the cells in the battery. I assume these are batteries with a built in BMS. If you can, try leaving them on low charge rate for longer. This will allow the BMS to complete internal balancing and the overall voltage will rise. Might take longer than you expect.

1 comment
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

schmit01 avatar image schmit01 commented ·
Yes, they have an internal BMS. I suppose the question is, is the 13.1v vs the 13.6 outside of the allowable voltage range and just return the battery. I shouldn't be havening to resolve this anyway.
0 Likes 0 ·
Alexandra avatar image
Alexandra answered ·

@Schmit01

Usually they would need to be both fully charged as individuals (when new) and balanced before putting them into the 24v system.

But still you will need a battery balancer. (Neat demo at the bottom) This is acommon situation in a built battery bank. Different internal resistances and a few other factors affect them, especially if they don't have comms between them.

3 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

schmit01 avatar image schmit01 commented ·

I get that and is what I am trying to do, but that is already 0.5v difference between batteries to start with. The one battery once fully charged will be around 14.1v then slowly settle down to around 13.65v. The other battery regardless just reads 13.15v. right after I pull the charger off but still accepts the full AH charge rate based off my Victron smart charger.

I just tried to balance the batteries in parallel and then also top them up in parallel, they wont balance. One is now sitting at 13.22v and the other 13.65v. I've checked and there is no flow of power between the batteries.

Yes I have the battery balancer, but that only works when charging and starts at 27.3v.
So yes the battery balancer will bring down the voltage of the higher battery, but that's 0.43v difference ever charge cycle, not every few months.

So I am just going to try take the battery back for a replacement.

0 Likes 0 ·
Show more comments

Related Resources

Additional resources still need to be added for this topic

Battery Compatibility

Did You Know - How to create a battery profile for non-Victron batteries?