This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi,
I want to build a little inverter system for home usage (mainly to run a TV and wifi during loadshedding - Yes, I am in South Africa). So I am looking at the SmartSolar MPPT 75/15, Phoenix Inverter 12/500, 160W solar panel and 102Ah deep cycle battery. I want to set it up as per the picture below but was wondering whether I can add the IP65 battery charger to the battery terminals as shown in the image. Will that cause any issues with the battery?
Yes it is. I have exactly the same set up.
Just be sure that the battery can take the amps from both chargers without causing damage.
Great, thanks @Alexandra. Stupid question but how would I know the amps that the battery can take? My IP65 is a 5A charger and the MPPT 15/75 can do 15A if I am not mistaken, so I would exceed the 102Ah battery's capacity?
Not likely with 20A of charge even if your battery is a lead acid or agm. Most can take that many amps.
Usually the information is in the battery datsheet or on the side of the battery.... Recommended charging amps. Do t forgt to set your voltages.
@Alexandra, one last question. Do I need the inverting remote on-off cable for my application, as shown in the image?
