This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
After rebooting my GX some modules were missing by marked as installed. Trying to remove them fails as does doing it manually via npm. No luck forcing a reinstall either.
Is there a way to reinstall/reset node red in the large image? I am running the current beta venus OS.
@Dirk-Jan Faber any suggestions?
thanks.
check if they are installed with the -g global command
https://nodered.org/docs/user-guide/node-red-admin
So with npm remove/install -g I could remove and install it again but the ui still does not show it as installed and is still marked as missing.
Thanks for the help.
Ok, that was a bit of an effort.
The /data partition was filling up and it appears when node red was trying to do something, it would stage packages and run out of space.
So I exported my flows.
Then booted the previous firmware image, disabled node red and via ssh, scrubbed the /data/home/nodered/.node-red/ folder.
I then upgraded to the current firmware and had a vanilla node red again.
I could reinstall my modules then import the flows again.
The volume is using less capacity now.
Ultimately the venus has less than half the space than the cerbo, and having loaded a node that was deceptively large (socketcan), it pushed it over the edge.
That indeed is the correct way to go to the factory defaults.
Note that you can add extra disk space via an external USB disk / stick.
