All, I've noticed that my 4x 100/30 MPPTs are not going to back to bulk charge after the last firmware update. I did some searching and can't seem to find this issue.
I have 4x 100/30 MPPTs that are using a ve.network with a Bluetooth voltage and temp sender. I'm on a boat and the engines combined with solar will touch 14.4v when we are motoring and this will drive the MPPTs into absorption/float. After we turn off the engines, the boat quickly drops to 13.3v. My re-bulk is set to 0.01V with a float of 13.4. I have even ran a tea kettle to drop the voltage temporarily to 13.0v, but the MPPT still wouldn't re-enter bulk.
I have disconnected the ve.network and I can go into each MPPT independently to turn off charging, then on charging and getting them back to bulk.
Any thoughts or suggestions?
Thanks, Jason
