Hi all,
I have 3x MPPT 50/100 and steer them via non-inverted remote cable from the Electrodacus BMS, so BMS switches on/off the MPPT to charge
Problem is if the plug of the non-inverted cable in the VE-Port of the MPPT goes out the MPPT switches on by default. That’s really bad because that plug sits very loose in the connector and gets disconnected easily, 2nd if remote cable gets damaged or disconnected the bank gets charged and could be damaged. One of the 3 is not smart so I need the VE-Bus connector to program the MPPT via BT dongle, on the other 2 I just glue the connector in.
Is there any way that remote functionality can be adjust so if plug disconnects it shuts off, I hope so….if not an extremely bad design….