Hello, I’m adding a smart BMS CL 12/100 to my system and as such will remove the VE Bus BMS. So do I remove the assistant on the multiplus 12/1600/70 ?
This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hello, I’m adding a smart BMS CL 12/100 to my system and as such will remove the VE Bus BMS. So do I remove the assistant on the multiplus 12/1600/70 ?
The VE.Bus BMS assistant is not needed for the Smart BMS.
@Big Ste Take a look at the schematic on the Victron Web Site for the CL 12/100
See the note regarding inverting remote on/off cables and the charge and load control inputs from the CL 12/100. In order to use these the VE.Bus BMS assistant will need switching for the "2-signak BMS support". This will allow you to select which of the aux ports has a charge control signal in a nd which has a load control signal. When either of these goes low, the Multiplus will either stop charging or switch load off.
Additional resources still need to be added for this topic
33 People are following this question.