question

21g avatar image
21g asked

CHARGER + BMV 700, Disconnect other cables when charging ?

Hello,

The seller couldn't answer me and i couldn't find any wiring diagram for my current setup, so i'm asking this to you guys:

Here's a diagram of my setup

diagram.jpg

Question: Do i need to disconnect every other cable on the battery when i want to charge it with the IP67 charger? I'm afraid of damaging the shunt or the inverter if i leave all the cables on while charging, i'm pretty new to this.


I was thinking of using the circuit breaker and then start the charge, but still, i'm not 100% sure that it'll prevent the inverter from being potentially damaged.

(It's obvious but just in case: on the diagram, the negative cable of the IP67 charger is connected on the "LOAD and CHARGER" side of the shunt.)

(I'm only willing to charge the battery when the inverter is off.)



BMV Battery MonitorchargerPhoenix Inverter
diagram.jpg (1.1 MiB)
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

2 Answers
bunya-solar-pl avatar image
bunya-solar-pl answered ·

Hi.

Your circuit looks fine to me. Should work perfectly as is. What makes you think that cables need to be re-arranged when charging?

3 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

21g avatar image 21g commented ·

So, I don't even need to use the circuit breaker when willing to charge?

The fact that the inverter would get some current flow from a charger and not the battery itself made me think that, I though it'd damage it somehow, thought the inverter couldn't handle this.


0 Likes 0 ·
Show more comments
kevgermany avatar image
kevgermany answered ·

@21g

The neg from the charger should be on the load, not the battery side of the shunt. Otherwise the charge current won't be recorded and the BMV won't show correct state of charge.

As said by @Bunya Solar PL no need to disconnect/shut off inverter while charging.

If you want a decent battery life, don't use more than 50% of its capacity and keep it fully charged.


1 comment
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

21g avatar image 21g commented ·

Yes the negative is already on the "load and charger" side on the shunt, thanks for your answer!

0 Likes 0 ·

Related Resources

Victron BMV battery monitors product page

Chargers.

Additional resources still need to be added for this topic

Phoenix Inverter product page

Phoenix Inverter Smart product page