This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi all
I have set up my absorption and float voltages on my Multiplus 2 48/8000/110, however it will not allow me to set the equalisation voltage and it tells me using the traction battery preset that the system can get to 68V, my battery supplier has said they should be taken to 62V.
Is there any other way to set the equalisation voltage, I know you can adjust it if it was an MPPT ?
Traction batteries require regular additional charging. In the equalisation mode, the MultiPlus-II will charge with increased voltage for one hour (1V above the absorption voltage for a 12V battery, 2V for a 24V battery). The charging current is then limited to 1/4 of the set value. The ‘bulk’ and ‘absorption’ LEDs flash intermittently.
Thanks for ACCEPTED ANSWER
Having searched further in to this it appears I am not alone in having this issue.
Seems like we are stuck with the equalisation voltage that Victron gives us if using a Multiplus 2, which is a bit lame when it is considerably different to the manufacturers settings.
