Victron Nube here, familiar with OTG and Inverters.
As the title states my Bulk and Absorption are constantly blinking yellow. In the manual it is stated that this is
"The mains voltage is switched through and the charger operates in equalize mode."
I have not requested an Equalize charge, I turned off that function via software.
Has anyone seen this ?
Links to Photos of System with Video - Click here for Google Gallery
I have pasted my config file below >
TAB: General System frequency 60Hz Shore current 8.0 A Overruled by remote checked Dynamic current limiter unchecked State of charge when Bulk finished 95.0 % Battery capacity 230 Ah Charge efficiency 0.95 TAB: Grid Country / grid code standard None: (feeding energy from DC to grid not allowed) Accept wide input frequency range (45-65 Hz) checked AC low switch mains off 94 V AC low switch mains on 101 V AC high switch mains on 138 V AC high switch mains off 143 V UPS function checked TAB: Inverter PowerAssist checked Assist current boost factor 2.0 Inverter output voltage 120 V Ground relay checked Inverter DC shut-down voltage 18.60 V Inverter DC restart voltage 21.80 V Low DC alarm level 21.80 V enable AES unchecked TAB: Charger Enable charger checked Weak AC input unchecked Stop after excessive bulk unchecked Lithium batteries unchecked Storage mode unchecked Use equalization (tubular plate traction battery curve) unchecked Charge curve Fixed Absorption voltage 24.40 V Float voltage 24.40 V Charge current 8 A Repeated absorption time 1.00 Hr Repeated absorption interval 7.00 Days Absorption time 1 Hr TAB: Virtual switch TAB: Usage Virtual switch usage Do not use VS TAB: Assistants TAB: Assistant Configuration Assistants not used