Hi, I upgraded firmware on the Cerbo GX in order to support a Ruuvi sensor over Bluetooth. That worked ok but the Multiplus 24/3000/70 won’t turn on when the VE bus cable is connected. Disconnect the cable and the multiplus turns on as expected. Reconnect and the multiplus turns off. This hardware was working before updating the Cerbo GX firmware. So I updated the Multiplus firmware to the latest an the same symptoms occur. If I turn on the Multiplus with the Cerbo GX disconnected it works fine and goes into inverting mode. Reconnect the VE bus cable and it turns off and the display (Touch 50) says it’s on but in an unknown state. If I re-power the Cerbo it comes back but switching the Multiplus off and on results in the Multiplus turning off and staying off until the cable is disconnected. Any insights are welcome.