question

wolf-lat avatar image
wolf-lat asked

Multiplus doesn't have correct grid code


My Multiplus 24/1200/25-16 does not have the correct grid code for my country, how can I add it to the Multiplus?

MultiPlus Quattro Inverter Charger
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

3 Answers
Alexandra avatar image
Alexandra answered ·

@Wolf_LAT

Use ve configure and go to the grid tab in software. Be aware it is a set once. You can't change it.

https://youtu.be/V1Zceq02vMA

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

wolf-lat avatar image
wolf-lat answered · 
I don't have the required grid code in the grid code selection tabimg-5213.jpg

img-5213.jpg (5.3 MiB)
3 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Alexandra avatar image Alexandra ♦ commented ·

@Wolf_LAT

If you dont have your country specifically then other is the one to choose... And welcome to the club.

But you only need to change it if you are using ESS assistant.

0 Likes 0 ·
wolf-lat avatar image wolf-lat Alexandra ♦ commented ·

Thanks.I want touse ESS assistant

0 Likes 0 ·
Matthias Lange - DE avatar image Matthias Lange - DE ♦ commented ·

Is VE.config and the firmware of the MultiPlus up-to-date?

0 Likes 0 ·
wolf-lat avatar image
wolf-lat answered · 
I want to use the assistant's ECC.
VE.Config current version- 9003242. Multiplus firmware -2617430.
2 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Alexandra avatar image Alexandra ♦ commented ·
@Wolf_LAT

Use victron connect and the mk3 adaptor and update the firmware of the inverter, and OTA update for the GX device you are using. As Matthias Lange - DE mentioned before proceeding.

Read here for instructions.

2 Likes 2 ·
Show more comments