This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi, I have Easy solar II 3000, 24V and a generator 3.9kw. Also 4x 240Ah batteries. My problem is that the voltage drops too low too easy. Today I charged the whole absorption phase, 20 minutes, with 29,3 V. With zero consumption, and Easy Solar shut down, the voltage is only 25,7V after 8 hours from charging.
Is there any important settings and where?
Pauli
4x 240Ah batteries.
What voltage batteries? 6-12-24v?
Is there any important settings and where?
I think this is your Easy Solar manual. Best to have a good read before tinkering with settings.
Batteries are 12V AGM Deep cycle. Connected to 24V system, 480Ah. Instructions I have read but
Still need help. I have made my settings but not sure if they are OK. And now After couple of hours leaving and thinking if the voltage 25.4V is enough for winter. After charging yesterday I have not used electricity. Pauli
