3 x multipus 24/3000 in parallel
Issue if I set the input current limit to say 20 amps. and then apply loads of say 18 amps then the input current exceeds this buy the battery charger setting power.
I then have to limit the battery current way down to say 6 amps per unit at 24 volts so that I can stay under the 20 amp current limit. while running other loads
I would have thought that the charging would have been reduced first to zero rather then exceeds the max current limit set when other loads are used.
also if I raise the max charge rate to 70 per inverter then the amps drawn goes way over the 20 amp limit eve with no loads.
have tried this with the DMC and the CCGX and by checking that the changes have been applied correctly to each inverter with ve config and they have been
firmware version 459
any ideas out there, pain in the backside changing the battery current limit setting all the time