This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi, I am planning to charge a 7S?P battery of 18650 cells with a charge controller normally intended for led acid battery.
I created a spreadsheet with my parameters, I would like a second opinion. I have a hard time deciding on the float/absorption voltages. I live in Morocco, plenty of sun and dead laptop batteries.
In the spreadsheet we can see the defaults for 12 and 24 volts and the values I decided for the battery (column in grey):
EDIT: adding new values:
Thanks!
I'd set float voltage close to or the same as absorption (4,1V?)
new charge cycle: not important if absorption is high enough
I also think 4,15V is a bit high (4,1 would be my choice)
What (kind of) BMS are you using? does it communicate with the charger?
Thanks @Boekel,
I am relying on the solar charge controller for the over-charge and over-discharge protection. As for the cell balancing, I am using an active balancer which kicks in whenever the voltage difference exceeds 100mv and stops when it is 30mv or less. It does it on any stage of charge.
So I don't have a BMS.
The pack is not done yet, so I will do my tests with 7S1P for now, then add up cells as the system is stable.
I will re-upload another screenshot after adjustments tomorrow!
EDIT: added new parameters in original question...
