This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Dear all,
sensed voltage of battery and battery BMS voltage is not same so it doesnot charge the battery to 100%.Battery actual voltage is lesser but multiplus sensed DC voltage is higher so multiplus stop charging the battery.please find the attached screen shots.pylontech US2000 with multiplus II 5kVA UNIT.
You need to start by manually checking all your wiring, connections, fuses etc with a meter to see where the voltage loss is originating. There is always a little loss, but when it is above average, it almost always is caused by something in the wiring chain.
Dear sir,
if its loss then victron inverter sense voltage should less than that pylontech battery voltage , but here its other way around inverter sense voltage is greater than the battery voltage.
No, the inverter will be higher as it is the charge source. The battery is lower, ie there is loss on the way down to the terminals.
Chart the different voltages over time and across higher and lower load. You should find it increases with load.
You can use a custom widget for this. Like so.
This is quite a common behaviour of Pylontec to reach close to 100%
It is mentioned in the Victron Pylon page. It has alot to do with their internal cell balancing as well.
It does get there eventually. We have quite a few systems in place now, so have seen the behaviour.
