Hello, I suggest to Victron to make a way that the equalization current of the smartsolar can be read by a smartshunt or a bmv via the VE smart network.
otherwise it is impossible to carry out a correct equalization phase if there are loads on the battery.
It is quite frustrating that the smartsolar can use the charging current of the smartshunt to terminate the tail current draw phase, and that it cannot do the same for the equalization phase.
for example if I set the equalization limit to 10% of the current of my smartsolar, it would be 3A (10% of 30A), but if I have 15A of loads on, the voltage will never increase because the charge controller cannot distinguish the current of the loads from that of the battery.
It would be very easy to do this since everything is already set up for the Ve Smart network.