question

shipbuilder101 avatar image
shipbuilder101 asked

Lynx Shunts sometimes not showing on Cerbo

Hello fellow enthusiasts!


I am encountering a very puzzling error.

I have two Lynx Shunts connected to my Cerbo.

However either 0,1 or 2 of these shunts are being displayed in the Overview Hub on my Cerbo Display as tiles (DC Power) and in the menu, after everything has booted.

That situation is also constant and it only changes upon reboot, where again, it is like a "throw of dice" which shunts will be shown.

I can confirm that the shunt lights are constantly glowing green.

Does anybody know what that may be?

Could you perhaps supply the CAN matrix for the shunts?


Thank you so much!

Venus OSVE.Canlynx shunt
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
Stefanie (Victron Energy Staff) avatar image
Stefanie (Victron Energy Staff) answered ·

@shipbuilder101

Have you checked Settings> System setup > Battery monitor? Only one of the two can be the system -wide shunt and should be selected manually.

4 comments
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

shipbuilder101 avatar image shipbuilder101 commented ·
@Stefanie I didn't set anything there yet, but would that still display both shunts simultaneously in the overview? If not, what would I need to do instead? After all, I have seen both shunts at the same time already before, which is exactly what I want. I just want them both to be displayed at all times, consistently not not be buggy and disappear occasionally with restarts.
0 Likes 0 ·
Show more comments

Related Resources

Victron Venus OS Open Source intro page

Venus OS GitHub (please do not post to this)

Additional resources still need to be added for this topic

Lynx Shunt VE Can online manual


Additional resources still need to be added for this topic