question

Stuart avatar image
Stuart asked

BMV700 not showing correct state of charge.

Hello everyone. I'm doing a test on my setup. Lithium battery stand alone for test purposes. BMV700 connected and a small fridge using 4A. The problem is my BMV has synchronised and is currently showing 98.2% after an hour of working with the fridge. The BMW is also showing the 4A being used but is only showing 13 hours remaining for a 100Ah battery. For me that means around 50Ah remaining so the battery is at around 50%. Is there a way to set this manually? I am totally lost. I do not have the dongle for bluetooth so have to do everything on the BMV itself.

BMV Battery Monitor
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
JohnC avatar image
JohnC answered ·

Hi @lowplainstu

The setting you're likely talking about is the 'Discharge Floor'. I think it comes defaulted to 50% (for Pb batt users), so the time remaining is calculated down to that. And yes, it's adjustable. If you haven't already, grab a copy of the manual from the Victron website.

3 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Stuart avatar image Stuart commented ·
Thanks John.

So for my lithium I could drop this down to 0 theoretically but for safety could set it at 10%. Is the relay part of the bmv and if not, can I disable this function. I have the full manual but it's a minefield .

0 Likes 0 ·
Show more comments