This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I have installed a lynx Shunt to the right of my power in and before my distributor. I have a cerbo GX and have the ethernet cable from victron and the termination plugs installed. I can't get the shunt to show up in my cerbo GX screen. It can see both of the MPPT's. Any idea what I am doing wrong?
It goes into one of the CAN ports, I think, not in the Ve.Bus or LAN. Check if you use the proper input.
I had the same problem, and suddenly one day I couldn't find it, but the bus didn't change and the RS450-200 MPPT was connected, and the MPPT worked fine.
