This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Is there a good reason not to move the green ground wire from the centre of the distributer as shown on this circuit diagram down to the other side of the smart BMS where I’ve drawn a green arrow?
My Distributer is very congested with connections, and it would make my life a lot easier…
You can ground the mass wherever you like ... also at the position you have marked, or at both.
I think this is only a representation of one possibility
The diameter should only be as large as possible in order to achieve the highest possible short-circuit current in the event of a fault.
