This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
After a new update of the firmware, the in built bluetooth stops working. I checked that is available from the Cerbo Bluetooth configuration (but the Bluetooth led is always off). I want to know if is an software issue and it will be solved soon or if I need to use the warranty to have a new cerbo.
Thanks!
Have you tried to reboot the Cerbo? Or roll back the firware to check?
It connects for about a day then will not recognise the password. What i see many times is 2 Cerbo GX's with the same name and it drops on my list of paired devises. Very frustrated with this expensive unit.
Hi, yes. I tried both but nothing solve the issue. I updated two new versions in one week (aprox). The current version is v2.89 and the previous one that I backed up is v2.87
If rolling it back did not work and it was working, and it is definitely enabled as @JohannDo mentioned, then I would get it checked at a service centre.
Is bluetooth enabled in the settings?
I was wondering earlier that aren’t you supposed to see your Multiplus/Quattro over bluetooth if it’s connected to Cerbo? I can see Cerbo just fine.
The Bluetooth is not necessary for local monitoring nor is it useful for that. It is used to set the wifi connection.
Use the inbuilt WiFi access point for local monitoring.
Yeah, I know that the are differents ways to connect all VictronConnect devices, all I want is the whole functionality that I pay for. I ask for some VictronConnect technician for some guidance.
Hi @Llucmajor, @Stephen, and others.
The built in bluetooth functionality in the Cerbo GX is limited to the initial configuration of an external wifi network.
Due to a limitation with the built-in bluetooth chip only operating at low temperatures, in order to see the built-in bluetooth connection the unit must be cold, such as when it first starts up. The built-in bluetooth availability can then disappear once the unit warms up (depending on ambient temperature and other loads on the Cerbo).
This is obviously not ideal, but the work around is that this external wifi network configuration function is also available via the built in wifi hotspot (connection details to this built in wifi hotspot are shown on a sticker on the Cerbo GX, and more details available in the Cerbo GX manual here - https://www.victronenergy.com/media/pg/Cerbo_GX/en/accessing-the-gx-device.html
I have heard some customers make the assumption that built in bluetooth connection can be used for more than just the initial setup of a wifi network password when first booting up - but there is no functionality beyond that.
Whats your advise?
OK - So as of 31 Aug 2022 you couldn't do anything with bluetooth. Now, 9 months later, you can use BT to connect to Ruuvi temp sensors. So how do we get BT to reset to for use with Ruuvi sensors?
