question

helmutm avatar image
helmutm asked

Which Cerbo GX FW to use with Cegasa eBick BMS TCC-CAN v02

Hello,

i like to connect a Cegasa CAN BMS to the Cerbo BMS CAN Port (CAT5 straight, terminator plugged in), but it wont be recognised an doesn't show up as a Battery Monitor.

The Cerbo has the most recent FW version from the release feed installed which is v2.89. The troubleshoot section of https://www.victronenergy.com/live/battery_compatibility:cegasa states, a firmware version v2.90 or later is to be used. Is it advised to install a v2.90~ from the release candidate feed?

Thank you!

best regards
Helmut

cerbo gxBMS
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

2 Answers
nickdb avatar image
nickdb answered ·

Support was only added in the 2.90~12 RC, so yes, you will need to run the RC if you want support ~14 is the current release.

See the topic in the modifications section.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

helmutm avatar image
helmutm answered ·

Thank you for the answer. It works after updating to RC 2.90~14

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.