Multiplus 48/5000 DC overvoltage

Question

replit

This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.

question

finalshare asked Jul 19, '22

Greetings,

i have an 48/5000 and a Cerbo.

i Hooked them up to my Workbench to Configure everything (as done many times before)

i have a 50 Volt Power Supply instead of batteries.

Now it had Some Fault and sent 100 Volts DC into the Multi and Cerbo.. both units are dead.

i can't find any blown up component inside.

i can Solder Pretty good, can anyone point me to a possible fault that occurred or do i need to Face 2.000$ in Dead Units.

Multiplus-II overvoltage

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Answer 1 · 2022-07-19T18:53:15Z

Mike Dorsett answered · Jul 19, 2022 at 06:53 PM

Most probably the inverter could be repaired with a new control board, but the cerbo will most certainly require replacement.

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.