I must be missing something...
I can not seem to find any way to update advanced charging parameters for my SmartSolar 250/100. Specifically I want to set the voltage and timing for the absorption and float modes.
My setup:
1 Quattro 48/5000/70
1 SmartSolar MPPT 250/100
2 homemade 280ah 48v batteries
1 raspberry pi 4 running venus OS
When I open the SmartSolar charger in the remote console the state shows "External Control" and there is no way to change any settings. In the vrm portal, I see the charger in the device list but there is no way to change settings. In VE Configure3 I can see Charger settings, but I think those are for the Quattro onboard charger (when it has generator power). If I use Victron Connect to bluetooth to the SmartSolar charger, I can see the settings when expert mode is enabled, but it still shows "External Control" as the mode.
What "External" device is managing that config? How to I set the parameters and enable viewingof which mode the charger is in?
Below you can see screenshots of each of the applications.