Hi. I have an MPPT solar charger, a Victron Lion battery, a Ve.BMS and a pheonix inverter all hooked up. The charge diconnect wire goes to the MPPT to disconnect if over voltage, the load disconnect wire goes to the Phoenix inverter to disconnect if the cell/battery voltage is too low. My question is what happens when (in this system) the load is disconnected (because of under-voltage) then the solar panels/charger bring the battery back up past the load disconnect voltage? If the load disconnect re-connects (does it?), without hysteresis the load will draw the battery back down and disconnect again almost immediately. If the BMS will re-connect the load (?) is there a way to set at what voltage this happens?