Hi @ all
Maybe this question is obvious, but not so much for me.
It seems that some configurations can only be made (like Assistants) with MK2/3 USB interface directly from the PC with VictronVE Config. However my entire house runs over the system. Does that mean I have to power down everything in case I want to change the config? Or can I just unplug the VE Bus from the Cerbo and can do everything while the system keeps going (maybe switched to Passthrough for the time being)? How does the procedure go normally?
I want to check how AC-2-out is connfigured. I have ESS mode so I would think when Power on AC-in goes away, that AC-2-out is dropped. However I want to have a way to "force" the system to power AC-2-out again if I want to (I guess the AC2-out relay somehow is controllable - but how?).
PS: Is there a modbus register I can read to figure out that "Mains" went away?
Thanks in advance