This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Goodmornign everyone,
I have a problem, the bmv 700 doesn't displays the incoming A (Ampere) from the solar panel, but it displays the A coming from 220W. Do i have to reset the bmv? What can i do to solve the problem? Thank you so much.
Have a great day
I dont understand the question fully
what do you mean Display the A coming from 220W
I have a problem, the bmv 700 doesn't displays the incoming A (Ampere) from the solar panel, but it displays the A coming from 220W. Do i have to reset the bmv? What can i do to solve the problem? Thank you so much.
La bmv mi legge l'amper in ingresso a 220v ma non quelli in ingresso dal pannello solare
I tried to use Google Translate, but it still doesn't make any sense.
Also what is the 220 reading? Is it W or V?
Sorry, it's a bit difficult to understand the problem well.
Grazie per la vostra pazienza, la corrente 220 è quella della casa che passa dal caricabatterie e la vedo sul BMV, ma non vedo la corrente proveniente dal pannello solare, quindi non so mai quando carica la batteria
I think there is some confusion with equipment. It is impossible for BMV to see 220V from the house. It can only measure battery.
Do you maybe mean CCGX? Maybe it will be better if you can show a photograph?
remove the brown wire from the battery and place it on the shunt as indicated
for that matter ALL the small brown wires should ALL be going to the shunt as indicated, not just the solar wire
you should ONLY have the one Neg cable going from the shunt to the battery
Thank you so much, you are too king and i will keep updated.
Unfortunatly sometimes who install this type of products doesn't know them so well..
Again thank you and have a good day!
