question

techoverland avatar image
techoverland asked

Tank Level Monitoring Raspberry Pi?

I am looking for a simple solution to run 2 KUS tank monitors with the Raspberry Pi Venus OS.

What is everyone else using?


Thanks!

tank monitor
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
johanndo avatar image
johanndo answered ·

Hydrostatic tanksensor 0-1m and I2C interface with a ADS1115

You could use them probably with a Victron USB tank interface too (current loop 4...20mA, 12V), very precise, +/- 1 liter on a 600l fresh water tankimg-20220522-095332.jpg


img-20220522-095332.jpg (238.2 KiB)
7 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

adamr100 avatar image adamr100 commented ·

Is the current loop always 4-20 or does it need to be adjusted.

I have the tank 140 connected to my lpg tank and water tank.

0 Likes 0 ·
johanndo avatar image johanndo adamr100 commented ·
There are 2 "standards", 0-20mA and 4-20mA. If you overload a sensor it may show more than 20mA, but usually the range is 4-20mA.
0 Likes 0 ·
Show more comments