Hi All,
i have the following setup:
ESS: 48/5000 + Mppt + 123bms 14kWh
sinds a few days the Cerbo cannot see the data from the 123BMS. but the rest seems to work fine. in de cerbo menu you can see the 123BMS but all data is empty.
after a power since then every thing works again, but after some time i have the same problem. also the cerbo sees a few 123bms but i have only 1 connected.
tried to update the cerbo but no luck, put i back to original software where it runs sinds i build it with no problems.
any idee?
many thanks for your help
Jos