I have a choice to use 3 or 4 MSE415SX6Z mission solar panels. These are 72 cell panels 48.91v open circuit. Originally I was going to just use 3 panels in series as that is what easily fits on my boat. 3 in series would be just under the 150v requirement for open circuit voltage. Then just use 1 set of the MC4 connectors on the controller. This would give me about 1200 watts of power. I have a 4th panel I could install but in close quarters this would need to be stored in the shade to avoid possible damage. I understand the MC4 connectors on the controller to be in parallel. If I used 4 panels I would need to configure 2 sets of 2 panels in series then each set connected to a set of the MC4 connectors (Parallel) on the controller. How will the one shaded panel effect the whole system? Should I just not use the 4th panel or get it its own controller?