Hi All,
I have the following setup:
- Multiplus II GX
- SmartSolar MPPT VE.Can 150/100 rev2
- BMV-712 Smart
- 48V 200AH Lead acid battery bank
Firmware on all devices is at latest. ESS assistant is enabled. MPPT and BMV are attached to the MP2 via Ve.Direct cables over USB.
BMV is set as the system battery monitor.
I have a strange issue where the MPPT is stuck at 0W, even when the panels are insolated. Yet isolating the MPPT from the battery and reconnecting seems to clear this fault.
I will add that the MPPT seems to work absolutely fine in standalone mode.
Has anyone seen this before? Or can any folks from the Victron side shed some light?