question

vectra avatar image
vectra asked

MultiPlus 12/1600/70 - MK3 USB - How to connect

I have one question. If I want to change or adjust the charging of the Multi with the MK3-USB interface, I always first disconnect the Cerbo GX from the Multi (pull out the network cable). Then I connect the PC with the MK3-USB interface. Can I keep the Cerbo GX connected (in parallel) when I connect the PC? Or is it better to only connect one device to the Multi at a time?

Greetings, Markus.


P.S.
Sorry for my bad English. My mother tongue is German.

MK3
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
klim8skeptic avatar image
klim8skeptic answered ·

It is ok to have the mk3 connected to your Multi 12-1600-70 at the same time as the Cerbo is connected.

The Multi will only communicate with 1 device at a time, ie a mk3, and block comms with the GX device.

venusmk3computer-lan.png

I unplug my mk3 from the computers usb port when not in use.


venusmk3computer-lan.png (142.4 KiB)
1 comment
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

vectra avatar image vectra commented ·

Hello and thank you for the answer.

Great, then I'll handle it a bit easier now, connect the MK3 in parallel if necessary and then remove it again.

0 Likes 0 ·

Related Resources

Additional resources still need to be added for this topic