I installed a CerboGX about 6 weeks ago. I installed 4 temp sensors and attached them to my alternator case, MultiPlus case, and generator. They were working fine, as was the CerboGX but then something went wrong and the Cerbo was fried (long story, tl;dr incorrect voltage).
When I installed the new CerboGX, using all the existing wiring eeverything worked fine except the Temp sensors are now reading way too high.
For example, the temp sensor on the Alternator (with the engine off) used to read about 21-23C. The one on the Multiplus would read between 25C - 38C when running full power.
But now they are all reading much higher - the Alternator sensor is showing 30C and the MultiPlus sensor is showing 33C at rest and up to 52C when running full power.
I know that I can configure an offset to "calibrate" the readouts, but, I can't help thinking that something happened to the temp sensors when the Cerbo was fried, or, something is wrong with my new CerboGX because something has to explain why the same sensors are reading 30% higher than last week.
Any ideas? TIA.