question

@grayjp5@hotmail.com

Unfortunately, this is not possible. The charging profile set via the VictronConnect app applies to all 3 outputs simultaneously.

What you want requires 3 independent chargers.

So all 3 banks need to be depleted to the same degree, always, or you will over charge the one that starts at a higher charge level?

I'm hoping that someone knows, definitively, how this Blue Smart IP22 12V 30A 3 output charger (available as 1 and 3 output versions) handles the specific needs of each of the 3 outputs independently? For example each of the connected batteries are depleted to different extents, perhaps 31 only requires maintenance/float whereas #2 requires charging from a 30% state. I wouldn't be so concerned except that the VictronConnect app only shows single charging information (as though this was a single output). It's a little difficult to envision a scenario when all 3 outputs should be handled as single..? Unfortunately Victron does NOT address this issue in ANY of the documentation. Lastly, is each output capable of 30A output (so for example the 3 output performs exactly the same as the 1 output version if only 1 output is being used)? Someone mentioned to me that they "thought" that the 3 output version was only capable of 10A per channel max, or perhaps 15A per output in the case where only 2 outputs were used.?