This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Has anyone used a Battery protect with a non victron lithium battery? The batteries would have internal BMS with no external communication capabilities. Could a person set switch/relay from a BMV or Venus (once the virtual switch update comes out?) to control the battery protect?
Yes I tried to do it a while back for a 10 KWh(5 Kwp) Lifepo4 witha 5 KVA quattro . The Battery protect does not allow the inverter power on showing a short circuit due to inrush charging current of the quattro.
However, I am using BP100/48 with a 800/48 Multi without any issues The BP gets switched(<20%) off on LOW SOC using BMV 702 . Mainly the reason is I already had BP and BMV 702 and did not want to spend to upgrade to BMV 712 ( recommended for Lithium due to low current)
But after playing around with the system with various combinations I realized that Most Lithium batteries need a BMS to properly balance and monitor the battery cells and most BMS have a LOW/High Voltage, SOC and short circuit protection making the investment in BP redundant.
Correct, you shouldn't connect an inverter to a contactor or Mosfet due to the inrush current. Also the for the battery protect, current should only flow in one direction so if the Quattro is setup to charge, you're probably going to damage the BP. If you have an external BMS with two signal (charge and discharge signals) you should wire them to the Quattro and program a two signal BMS assistant.
And the BP isn't redundant in my opinion. It can be used for disconnecting DC loads when a BMS triggers a low voltage alarm. It can also be used to disconnect dumb charge sources that don't have on/off abilities for a high voltage alarm.
How would you want it to be controlled? What parameter would you want the BP to turn off or turn on at? Maybe you can use the BMVs internal relay to trigger the bmv to shut off the BP.
Exactly- If i set a high/low voltage and temperature alarms on the BMV could the BMV relay control the BP? I just want to ensure that everything i would need with regards to the BP is there and capable of doing this? Alternatively, if i could connect it to the Venus GX which would have the same information, it may be better as the Venus would also have information from the Charging side of the system.
