This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
My Victron shunt and Multiplus are showing 2 different SOC readings. The shunt is showing 100% but the 24/3000/70 is showing anywhere from 70-80% SOC. I have programmed the shunt to know that the battery bank has 412aH @ 24v nominal.
How do I know which reading is accurate, or if either of them even are correct at all?
is there any specific reason why you have the MultiPlus battery monitor activated when you also have a BMV/SmartShunt? There should only be one battery monitor in the system.
The shunt is the the one to trust while the MultiPlus internal battery monitor relies on calculated data.
That being said, how do I make the SOC reading accurate with the shunt? I'll be charging from solar at 20 amps while the SoC reads 100%
Please post screenshots of your shunt settings and also battery settings from your MPPT.
Batteries:
4x SOK 206Ah 12v
2 Series, 2 Parallel, for 412Ah @ 24v configuration
Victron MPPT (100/50):
Battery Voltage: 24v
Max Charge Current: 50a
Charger: Enabled
Battery Preset: User Defined
Expert Mode: ON
Absorption Voltage: 29.2v
Float Voltage: 27.6v
Equalization Voltage: 29.2v
Rebulk Voltage Offset: 0.80v
Absorption Duration: Fixed
Absorption Time: 15 Minutes
Tail Current: Disabled
Equalize Current: 0%
Automatic Equalization: Disabled
Equalize Stop Mode: Automatic (On voltage)
Maximum Equalize duration: 0 Minutes
Manual equalization: DO NOT CLICK START
Temperature Compensation: Disabled
Low Temperature Cutoff: Disabled
Victron Multiplus 24/3000/70 Inverter:
Charge Current: 50a
Absorption Voltage: 29.2v
Float Voltage: 27.6v
Equalization: DISABLED
Victron SmartShunt:
Battery Capacity: 412Ah
Charged Voltage: 27.6v
Discharge Floor: 10%
Tail Current: 2.00%
Charged Detection Time: 3m
Peukert Exponent: 1.05
Charge Efficiency Factor: 98%
Current Threshold: 0.10a
Time-to-go averaging Period: 3m
Battery Starts Synchronized: Disabled
