Inverter RS 48/6000 + 4xPylontech US2000C + CerboGX + MPPT 150/35 High Voltage Error

Question

replit

This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.

question

pvittali asked May 11, '22

I use the above configuration and I have two issues:

1) I get Battery Monitor [512] - High voltage alarm: Alarm, the battery voltage is 52.41 V, SOC 100%

Do I need to adjust settings on the Inverter RS ?

I have activated DVCC and limited the charge current to 100A , all other options are disabled.

2) The MPPT 150/35 is connected to the Cerbo with VE.Direct and it shows up in the Device List but not on the dashboard of the VRM instance. Why ?

inverter rs

2

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Alexandra ♦ commented · May 11, 2022 at 05:02 PM

How much pv do you have installed have you follwed the 8x float rule for VOC?

Also Pylontec does do this if they are new for a bit then calm down a bit. I also think maybe you should have one more on the system

0 ·

Show more comments

Answer 1 · 2022-05-11T17:02:56Z

nickdb answered · May 11, 2022 at 05:02 PM

Is it a new install? If so, read the pylon setup guide - cell imbalances can cause this early on, best left on keep charged setting, if using ess.

1

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

pvittali commented · May 11, 2022 at 06:46 PM

yes its a new install ...

0 ·