I have the following two devices:
Cerbo GX Firmware v2.80
BlueSolar MPPT 150/60 Firmware 1.56 (just upgraded from unknown version (I forgot to make a note!))
There is a VE.direct connection between the two devices.
Victron Connect talks to the Cerbo GX via WiFi/wired ethernet.
Before upgrading the MPPT firmware I was able to see the MPPT device in Victron Connect, but after upgrade I cannot.
I have, with no effect.
0. Rebooted my network hub and switch
1. Rebooted the MPPT
2. Rebooted the Cerbo GX
3. Uninstalled and re-installed Victron Connect.
4. Connected to the Cerbo GX by bluetooth rather than WiFi.
My system appears properly in the Cerbo GX and console and normally in VRM.
Does anyone have any ideas?
Paul