This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
It is possible to use in a Multiplus the AUX I/O for Allow-to-charge and the Temp Sensor for Allow-to-discharge commands.
Do I have to connect both connection for this function, or is it possible to connect only the AUX I/O alone for Allow-to-Charge, leaving the Temp Sensor connection unused and unconnected?
My BMS has only one free relay output left and I need only the charge disconnect function for the Multiplus.
Welcome @Skokie ;-)
See if this helps: https://community.victronenergy.com/questions/36764/simple-switch-for-charger-off-multiplus-3000-12120.html
You need to get familiar with Assistants if you are going to use AUX I/O for ATC.
The temperature sensor for the Multi is not needed. Your BMS should take care of it and open ATC in case temperature is too low to charge.
Hi @Stefanie, thanks for this quick response.
I think this will fit. When going back to my boat on Saturday, I try to get familiar with the assistants. ;)
Man könnte sich auch theoretisch schonmal damit auseinandersetzen. Der Samstag ist kurz ;-)
Hier ist eine Übersicht der verfügbaren Assistenten: https://www.victronenergy.com/live/assistants:overview_of_available_assistants
Und eine kleine Anleitung, um was es bei Assistenten überhaupt geht, wie man sie einfügt und konfiguriert etc.: https://www.victronenergy.com/live/assistants:start
Du brauchst den 'Charge current control'.
